How to Use Your Therava™ 3-in-1 Back Massager"

How to Use Your Therava™ 3-in-1 Back Massager

Thanks for choosing Therava™! Below you'll find step-by-step instructions, troubleshooting tips, and important information to get the best results from your device.

Quick Start Guide

  1. Connect to Power:
    • Plug the massager into a wall adapter rated 5V 2A / 5V 2.4A / 5V 3A. It must remain plugged in to operate.
    • When plugged in, the lights will briefly flash red, blue, and green, then turn off. The green light on the power port means the massager is ready.
  2. Power On (Automatic Mode):
    • Hold the power button (with the power icon) for 3 seconds until the red light turns on. The massager will cycle between vibration, heating, and traction lifting.
  3. Switch to Manual Mode:
    • Hold the manual button (hand icon) for 3 seconds. The blue light will turn on, indicating manual mode.
    • Press the manual button again to toggle between:
      • Vibration Massage (blue light)
      • Traction Lifting (green light)
      • Heating (red light)
  4. Turn Off:
    • Hold either button for 3 seconds to power off, or the device will shut off automatically after 30 minutes.

Important Information

  • Power Requirements: The Therava™ Back Massager operates only when plugged in. It does not have a built-in battery.
  • Use the Correct Adapter: Always use a wall adapter rated 5V 2A, 5V 2.4A, or 5V 3A. Higher voltage adapters can damage the device.

FAQs & Troubleshooting

1. Is the massager rechargeable?
No, the Therava™ Back Massager is designed to operate only when plugged in.

2. Why isn’t my massager turning on?
When plugged in, the lights should briefly flash red, blue, and green, then turn off. The green light on the power port means it’s ready. Hold the power button for 3 seconds to start automatic mode.

Need Help?

If you have any issues or questions, email us at help@mysoothelab.com or visit our Product Issue Upload Page.